Spectre 0 Report post Posted August 20, 2004 This is the first time I've ever had to turn to the community for help... but I'm desperate.My hard disk sort of died today. It's been grinding down for ever, and it eventually kicked it in this morning.It's a 10gb drive sitting in an old IBM PC300GL I use for misc stuff - sometimes for the server, or to do misc jobs like encryption cracking, or whatever.Anyway, it's not so much the drive itself which is important - I could buy a replacement one for probobly under $10 - but having the data which I had stored on it is a matter of life or death. I'm too stupid to make regular backups, so there's about three months of work stored on there which I now can't get to, and which I didn't backup anywhere else - stupidly.I've tried just about everything that I know of to try and revive it - freezing it, running a hair-dryer over it, dropping it from about a foot, whacking the crap out of it with the butt of a screwdriver, and a few other weird but useful methods for resurecting drives I've picked up along the way - but it still isn't working.Any more suggestions, anyone? Basically, if I can't recover what I had stored on there, I might as well go and put some concrete boots on lay-by down at the local market. It really is that important.What happens when I try and get it to spin up is... absolutely nothing. The little light flashes as normal, but the motors don't kick in. It sounds like they start to churn, but then sort of give up after a second or two. Sometimes, the motors will try and start - but then it sounds like the arm that supports the head-readers are just flicking back and forth very fast, making a loud whirring sort of a sound. I've been having this problem for a while whenever I've turned the beast off and then gone to turn it back on, but usually it comes to life after flicking the power switch a few times.I am in desperate need of help here. And I can't afford to send it away to a data-recovery specialist, so don't suggest that. Share this post Link to post Share on other sites
OpaQue 15 Report post Posted August 20, 2004 Take another harddisk to your friends place and connct it as a secondary master. It should allow the pc to start normally. then you may go for recovery tools available in the downloads sites and recover it. but I don't think software methods would help much. and even they do help, you got to have something else to boot from.. This is all I can suggest. My second suggestion is banned from you, which is propably, take it to a speacialist. Share this post Link to post Share on other sites
Spectre 0 Report post Posted August 20, 2004 It's not the actual computer; just the drive. I've got like 30 boxes lying around my place, so hooking it up to a second box as a slave and ghosting it wouldn't be a problem, if the drive actually worked. Which it doesn't. So I think I'm pretty screwed.I'm too poor to fork out hundreds (or even thousands) of dollars to get the data recovered from it by some specialist. Share this post Link to post Share on other sites
Shackman 0 Report post Posted August 20, 2004 I've tried just about everything that I know of to try and revive it - freezing it, running a hair-dryer over it, dropping it from about a foot, whacking the crap out of it with the butt of a screwdriver, and a few other weird but useful methods for resurecting drives I've picked up along the way - but it still isn't working.You probably spoilt the disk with all that. Basically from what I read from your post is that it is a hardware failure. The motors don't kick in. This usually means that the hard disk is getting old or something. However, the data inside is usually safe.You could try something like this, but its extremely risky and i shall not take any responsibility whatsoever....You could buy the exact same hard disk. So now the new hard disk we shall call it A and the one that died down on you B. You can try to open B up and take out the discs and placing them in B, exactly where it should be.This is just a suggestion, and I think you should understand what I mean. Anyway, its really risky... Share this post Link to post Share on other sites
Spectre 0 Report post Posted August 20, 2004 You probably spoilt the disk with all that.No... if a physical disk is on its last legs, then you can generally bring it back to life for at least long enough to get the data off of it in the strangest of ways. Trust me, I've been doing it for years. Dropping it from about 10 inches, heating it up, spinning it around a few times on a flat surface - sounds strange, but it does often work. I think the problem is that some bearings have either become stuck, or worn down beyond the point of use - so by trying to shift them round (eg. by jarring the disk) could possibly breath life back into it again.I am aware that it's a hardware failure. And I said that the disk was 10gb, which sort of suggests that it is relatively old. And considering it stays grinding away pretty much around the clock, it has had some serious use.I would most definately not risk opening the disk - a single speck of dust on those layers can completely destroy it all. And it would be next to impossible to remove and replace them in a standard home/office environment witout a little dust being involved.The data inside would be safe - but I'm still not willing to risk 'transplanting' the discs. It's just too risky, as you said. Share this post Link to post Share on other sites
iGuest 3 Report post Posted August 26, 2008 How to revive my dead harddisk Dead Hard Disk Hi, I kind of need help to revive my dead harddisk. I had a dell inspiron 8100 that gave me screen issues so I took out the harddrive and got an external casing and used it as an external drive. I have had no problems with it until recently when it suddenly went dead, its not being seen as a drive at all. How can I either revive it or recover my data?? Its an IBM travelstar model IC25N030ATDA04 -question by Mike Share this post Link to post Share on other sites
bluedragon 0 Report post Posted August 27, 2008 How to revive my dead harddisk Dead Hard Disk Hi, I kind of need help to revive my dead harddisk. I had a dell inspiron 8100 that gave me screen issues so I took out the harddrive and got an external casing and used it as an external drive. I have had no problems with it until recently when it suddenly went dead, its not being seen as a drive at all. How can I either revive it or recover my data?? Its an IBM travelstar model IC25N030ATDA04 -question by Mike I can't understand your problem properly but still i'll try to provide you with a solution. There could be two possibilities , either your Hard-Disk has stopped working or your casing is having problems. If its the casing (you can check by connecting your drive as an internal drive on some other system) you'll have to buy a new one and the problem is solved. If its the hard-drive problem , I'll suggest you go for a professional company to recover your data(only if its worth it Otherwise you can try and use many software s out there for this recovery). One is "Stellar phoenix data recovery". Its not free though. Share this post Link to post Share on other sites
minimcmonkey 0 Report post Posted December 16, 2008 If the drive is physically worn out or damaged, you should not attempt to use it, or recover it with commonly available software, or that could make it impossible to restore the data...If the data is very important, you should send it to a data restoration lab. This can be quite expensive, but, presuming you use a good one, will have experienced staff, who can remove the data from the drive, and send it to you.If the data is important, its the best step you can take.It is best not to try to restore it yourself, as this could damage it further, and beyond the point where data can be restored. Share this post Link to post Share on other sites
